Nissan Sentra manuals

Nissan Sentra Owners Manual: Checking engine coolant level

Check the coolant level in the reservoir when


Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level B , add coolant to the MAX level A . If the reservoir is empty, check the coolant level in the radiator when the engine is cold. If there is insufficient coolant in the radiator, fill the radiator with coolant up to the filler opening and also add it to the reservoir up to the MAX level A .

This vehicle contains Genuine NISSAN Long Life Antifreeze/Coolant (blue). The life expectancy of the factory-fill coolant is 105,000 miles (168,000 km) or 7 years. Mixing any other type of coolant or the use of non-distilled water will reduce the life expectancy of the factory-fill coolant.

Refer to the NISSAN Service and Maintenance Guide for more details.

If the cooling system frequently requires coolant, have it checked by a NISSAN dealer.

Engine cooling system
The engine cooling system is filled at the factory with a pre-diluted mixture of 50% Genuine NISSAN Long Life Antifreeze/Coolant (blue) and 50% water to provide year-round anti-freeze and coolant ...

Changing engine coolant
A NISSAN dealer can change the engine coolant. The service procedure can be found in the NISSAN Service Manual. Improper servicing can result in reduced heater performance and engine overheati ...

Other materials:

C1116 Stop lamp switch
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1116 STOP LAMP SW When stop lamp switch circuit is open. Harness or connector Stop lamp switch ABS actuator and electric unit (control unit) ...

B0093 FRont door satellite sensor LH
Description DTC B0093 FRONT DOOR SATELLITE SENSOR LH The front door satellite sensor LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the front door satellite sensor LH for internal failures and its circuits for communication errors. PART LOCA ...

Main line between ipdm-e and dlc circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector E4 Harness connec ...

В© 2014-2026 Copyright b17.nisentra.com