Nissan Sentra manuals

Nissan Sentra Owners Manual: ECO mode switch

ECO mode switch
ECO mode switch

The ECO mode helps to enhance the fuel economy by controlling the throttle sensitivity and transmission points (CVT if so equipped).

To turn on the ECO mode, push the ECO mode switch. The ECO mode indicator light (on the speedometer) will remain lit while the mode is active.

To turn off the ECO mode, push the ECO mode switch again. The ECO mode indicator light (on the speedometer) will turn off.

The ECO mode cannot be turned off while the accelerator pedal is depressed, even if the ECO mode switch is pushed to OFF. Release the accelerator pedal to turn off the ECO mode.

The ECO mode will turn off automatically if a malfunction occurs in the system.

Turn off the ECO mode, or depress the accelerator pedal fully when:

NOTE:

Selecting this drive mode will not necessarily improve fuel economy as many driving factors influence its effectiveness.

Gear shift indicator (Manual transmission only) (if so equipped)

The Gear Shift Indicator (GSI) is used to support


The Gear Shift Indicator (GSI) is used to support the suitable timing of gear change. It operates only when the ECO mode is in the “ON� state.

The shift indicator icon 2 and recommended gear position 3 are displayed.

The shift indicator icon indicates when to upshift or downshift for fuel economy.

NOTE:

SPORT mode switch
Adjusts the throttle sensitivity and transmission points (CVT only) to enhance performance. Press the SPORT button on the instrument panel to activate. The SPORT mode indicator light (on the s ...

Cruise control (if so equipped)
...

Other materials:

Compression pressure
Inspection Warm up the engine to full operating temperature. Release fuel pressure. Refer to EC-143, "Work Procedure". Remove ignition coil and spark plug from each cylinder. Refer to EM-46, "Exploded View". Connect engine tachometer (not required in use of CONSULT). ...

Side window glass
Components Side window glass Spacer Headlining Rear body pillar Rear pillar finisher Rear door weatherstrip Primer area Adhesive 7 mm (0.3 in) 12 mm (0.5 in) Removal and Installation REMOVAL Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FIN ...

Windshield glass
Exploded View Windshield glass molding Spacer Rubber dam Windshield glass Windshield insulator Front pillar finisher Instrument panel Cowl top cover Roof panel Cowl top Body side outer Headlining Adhesive 12 +2.0 mm (0.5 +0.08 in) 7 +2.0 mm (0.3 +0.08 in) ...

© 2014-2026 Copyright b17.nisentra.com