Nissan Sentra Service Manual: Door mirror remote control switch
Removal and Installation
Removal
- Remove the instrument finisher D. Refer to IP-14, "Exploded View".
- Using suitable tool (a) release the pawls and remove the door mirror remote control switch (2) from the switch bracket (1).
Pawl
Installation
Installation is in the reverse order of removal.
Door mirror
Exploded view
Door mirror cover
(with side turn signal lamp)
Door mirror housing
Door mirror actuator
Glass mirror
Door mirror cover
(without side turn signal lamp)
: Pawl
Doo ...
Other materials:
Garage Jack and Safety Stand and 2-Pole Lift
WARNING:
Park the vehicle on a level surface when using the jack. Make
sure to avoid damaging pipes, tubes,
etc. under the vehicle.
Never get under the vehicle while it is supported only by the
jack. Always use safety stands when
you have to get under the vehicle.
Place wheel chock ...
M&a branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the combination meter for damage,
bend and loose connection
(unit side and connector side).
Is the inspection result nor ...
Warning lights
Anti-lock
Braking
System (ABS) warning light
When the ignition switch is placed in the ON
position, the Anti-lock Braking System (ABS)
warning light illuminates and then turns off. This
indicates the ABS is operational.
If the ABS warning light illuminates while the
engine is running or ...
