With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on:

If equipped, the following lights come on briefly and then go off:

If any light fails to come on, it may indicate an open circuit in the electrical system.
Have the system repaired promptly.
Warning/indicator lights and audible reminders
Warning lightsUnit removal and installation
TRANSMISSION ASSEMBLY
Exploded View
Transaxle assembly
O-ring
CVT fluid charging pipe
CVT fluid charging pipe cap
Tightening must be done following the installation procedure. Refer to
TM-283, "Removal and Installation".
: Always replace after every
disassemb ...
Vehicle Recovery (Freeing a Stuck Vehicle)
Front
Remove the hook cover from the bumper using a remover tool.
Securely install the vehicle recovery hook stored with jacking
tools.
Check that the hook is properly secured in the stored place after use.
WARNING:
Stand clear of a stuck vehicle.
Do not spin your tires at high s ...
P0962 Pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0962
PRESSURE CONTROL SOLENOID
A
(Pressure Control Solenoid A
Control Circuit Low)
The line pressure solenoid valve current is 200
...