Anti-lock Braking System (ABS)
warning light
Brake warning light
Charge warning light
Door open warning light
Engine oil pressure warning
light
Low fuel warning light
Low tire pressure warning light
Low windshield-washer fluid
warning light
NISSAN Intelligent Key® lock
warning light
(M/T models) (if so equipped)
NISSAN Intelligent Key® warning
light (if so
equipped)
Power steering warning light
P position selecting warning
light
(CVT models) (if so equipped)
Seat belt warning light
Supplemental air bag warning
light
Continuously Variable
Transmission (CVT)
position indicator light (CVT models)
Cruise main switch indicator
light
(if so equipped)
ECO mode indicator light
Engine start operation indicator
light
(if so equipped)
Front fog light indicator light
(if so equipped)
Front passenger air bag status
light
High beam indicator light (blue)
Malfunction Indicator Light
(MIL)
Overdrive off indicator light (CVT
models)
Security indicator light
Side light and headlight
indicator light (green)
Slip indicator light
SPORT mode indicator light
Turn signal/hazard indicator
lights
Vehicle Dynamic Control (VDC)
off indicator
light
Compass display (if so equipped)
Checking bulbsUnbalance steering wheel turning force (torque variation)
Description
Unbalance steering wheel turning force (torque variation).
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
Turn the ignition switch OFF to ON.
Perform EPS self-diagnosis.
Is any DTC detected?
YES >> Check the DTC. Refer to STC-14, "DTC Index&quo ...
Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final
tightening with grounded and unloaded vehicle
condition, and then check wheel alignment.
Observe the following precautions when disassembling.
Before disassembly, thoroughly clean the outside of the
unit.
...
Using the system
Initialization
When the ignition switch is in the ON position,
NISSAN Voice Recognition is initialized, which
takes a few seconds. When completed, the system
is ready to accept voice commands. If
the button is pressed before the
initialization
completes, the system will announce: “Voice
...