Nissan Sentra manuals

Nissan Sentra Owners Manual: Bluetooth® Hands-Free Phone System voice commands

To access the Bluetooth® Hands-Free Phone System voice commands:

  1. Press the Say “Call” and then a name in the vehicle button.

  2. Say “Call” and then a name in the vehicle phonebook to call that entry. Otherwise, say “Phone” to access various phone commands.

If the Bluetooth® has been set to “Off”, the system announces: “Bluetooth® is off. Would you like to turn Bluetooth® on?” If no phone is connected to the system and the vehicle is stationary, the system announces: “There is no phone connected.Would you like to connect a phone now?” Say “Yes” to connect a phone. All further Bluetooth® Hands-Free Phone System voice commands are only available if a phone is connected.

If a phone is connected and Bluetooth® is set to “On”, the following voice commands are available:

Allows for up to 24 digits to be dialed. After the number is entered, say “Dial” to initiate dialing. Say “Correction” to correct the number entered. Say “Go Back” to return to the main menu.

Starting with the first alphabetical entry in the vehicle phonebook, the system prompts for an additional command. Say “Dial” to call the number of the phonebook entry. Say “Send Text” to send a text message to the number of the phonebook entry. Say “Next Entry” to skip to the next alphabetical entry in the vehicle phonebook, where the same options will then be available.

The system prompts for an additional command.

Say “Missed Calls”, “Incoming Calls” or “Outgoing Calls” to display a list of such calls on the screen.

Speak the number of the entry displayed on the screen to dial that number or say “Next Page” to view entries on the next page (if available).

Redials the last called number.

Reads an incoming text message. For more information about text messaging with the Bluetooth® Hands-Free Phone System, see “Bluetooth® Hands-Free Phone System with Navigation System” in this section.

Sends a text message. For more information about text messaging with the Bluetooth® Hands-Free Phone System, see “Bluetooth® Hands-Free Phone System with Navigation System” in this section.

The system replies “Please use manual controls to continue”. Use manual controls to change the active phone from among the listed phones connected to the vehicle.

For more information about the Bluetooth® Hands-Free Phone System, see “Bluetooth® Hands-Free Phone System with Navigation System” in this section.

System features
NISSAN Voice Recognition can activate the following systems: Bluetooth™ Hands-Free Phone System Navigation Audio Information My Apps For additional information on the navigation ...

Navigation System voice commands
The following voice commands are available for the Navigation System: Street Address (address) Points of Interest (name) POI by Category Home Address Book Previous Destinations Enter ...

Other materials:

Dtc/circuit diagnosis
U1000 can comm circuit DTC Logic Dtc detection logic Consult display Dtc detection condition Possible cause Can comm circuit [u1000] Av control unit is not transmitting or receiving can communication signal for 2 seconds or more. CAN communication system. ...

6M/T
6M/T : Exploded View (LH) Circular clip Dust shield Slide joint housing Snap ring Spider assembly Boot band Boot Shaft Damper band Dynamic damper Circular clip Joint sub-assembly Wheel side 6M/T : Disassembly and Assembly (LH) DISASSEMBLY (WHEEL SIDE) CAUTION: ...

Basic inspection
Diagnosis and repair workflow Work flow Overall sequence Detailed flow 1.Obtain information about symptom Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.Check symptom ...

© 2014-2026 Copyright b17.nisentra.com