Nissan Sentra manuals

Nissan Sentra Owners Manual: Air conditioner operation (if so equipped)

Start the engine, turn the fan control dial to the desired position, and press the  activate the air conditioner. When the  air conditioner button to
activate the air conditioner. When the  air conditioner is on, cooling and dehumidifying functions are added to the heater operation.

The air conditioner cooling function operates only when the engine is running.

Cooling

This mode is used to cool and dehumidify the air.

  1. Press the position. button to the OFF
    position.
  2. Press the button. air flow control
    button.
  3. Turn the fan control dial to the desired position.
  4. Press the indicator light button. The
    indicator light comes on.
  5. Turn the temperature control dial to the desired position.

Dehumidified heating

This mode is used to heat and dehumidify the air.

  1. Press the position. button to the OFF
    position.
  2. Press the button. air flow control
    button.
  3. Turn the fan control dial to the desired position.
  4. Press the indicator light button. The
    indicator light comes on.
  5. Turn the temperature control dial to the desired position.

Dehumidified defogging

This mode is used to defog the windows and dehumidify the air.

  1. Press the button. air flow control
    button.
  2. Turn the fan control dial to the desired position.
  1. Turn the temperature control dial to the desired position.

Operating tips

Heater operation
This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. Press the button to the OFF position for normal heating. ...

Air flow charts
The following charts show the button and dial positions for MAXIMUM AND QUICK heating, cooling or defrosting. The air recirculation button should always be in the OFF position for heating and defr ...

Other materials:

Both side headlamps (lo) are not turned on
Description The headlamps (both sides) do not turn on in any lighting switch setting. Diagnosis Procedure 1.Check combination switch (lighting and turn signal switch) Check the combination switch (lighting and turn signal switch). Refer to BCS-72, "Symptom Table" (with Intelligent ...

Front power window motor
Removal and Installation REMOVAL Remove the front door glass regulator (2). Refer to GW-16, "Removal and Installation". Remove the bolts (A) and the front power window motor (1). INSTALLATION Installation is in the reverse order of removal. ...

Washing
Wash dirt off with a wet sponge and plenty of water. Clean the vehicle thoroughly using a mild soap, a special vehicle soap or general purpose dishwashing liquid mixed with clean, lukewarm (never hot) water. CAUTION Do not use car washes that use acid in the detergent. Some car washes, es ...

© 2014-2026 Copyright b17.nisentra.com