Nissan Sentra manuals

Nissan Sentra Service Manual: Periodic maintenance

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / 6MT: RS6F94R / Periodic maintenance

M/T OIL

Inspection

OIL LEAKAGE

Make sure that gear oil is not leaking from transaxle or around it.

OIL LEVEL

  1. Remove filler plug (1) and gasket from transaxle case.
  2. Check the oil level from filler plug mounting hole as shown.

CAUTION:

Do not start engine while checking oil level.

  1. Set a gasket on filler plug and then install it to transaxle case.

CAUTION:

Do not reuse gasket.

  1. Tighten filler plug to the specified torque. Refer to TM-30 "Exploded View".

CAUTION:


CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Draining

  1. Start engine and let it run to warm up transaxle
  2. Stop engine. Remove drain plug (1) and gasket, using a suitable tool and then drain gear oil.
  3. Set a gasket on drain plug and install it to clutch housing, using a suitable tool.

CAUTION:

Do not reuse gasket.

  1. Tighten drain plug to the specified torque. Refer to TM-30, "Exploded View".

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Refilling


Refilling

  1. Remove filler plug (1) and gasket from transaxle case.
  2. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown.

Oil grade and viscosity : Refer to MA-11, "Fluids and Lubricants".

Oil capacity : Refer to MA-11, "Fluids and Lubricants".


  1. After refilling gear oil, check the oil level. Refer to TM-19, "Inspection".
  2. Set a gasket on filler plug and then install it to transaxle case.

CAUTION:

Do not reuse gasket.

  1. Tighten filler plug to the specified torque. Refer to TM-30, "Exploded View".

CAUTION:

Do not overtighten the filler plug as this could cause the transaxle case to crack.

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary ...

Removal and installation
SIDE OIL SEAL Removal and Installation REMOVAL Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and Installation (LH)". Remove differential side oil seals (1) from clu ...

Other materials:

Side window glass
Components Side window glass Spacer Headlining Rear body pillar Rear pillar finisher Rear door weatherstrip Primer area Adhesive 7 mm (0.3 in) 12 mm (0.5 in) Removal and Installation REMOVAL Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FIN ...

Idle air volume learning
Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: Each time electric throttle control actuator or ECM is replaced. Idle speed or i ...

CSC(concentric slave cylinder)
Exploded View Transaxle assembly CSC (Concentric Slave Cylinder) Removal and Installation CAUTION: Do not reuse CSC (Concentric Slave Cylinder). The CSC slides back to the original position every time the transaxle assembly is removed. This action may allow dust or contamin ...

В© 2014-2026 Copyright b17.nisentra.com