Symptom diagnosis
Clutch pedalCan communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on CAN communication system.
Check terminals and connectors for damage, bend and loose connection.
Is the inspection resu ...
ABS Warning lamp
Component Function Check
1.CHECK ABS WARNING LAMP FUNCTION
Check that ABS warning lamp in combination meter turns ON for
approximately 2 seconds after ignition switch
is turned ON.
Is the inspection result normal?
YES >> Inspection End.
NO >> Proceed to diagnosis procedure. ...
Rear air spoiler
Removal and installation
Rear air spoiler
High mounted stop lamp connector
(if equipped)
Trunk lid
Grommet
Nut
Front
Removal
Remove trunk lid finisher. Refer to INT-45, "Removal and Installation".
Disconnect the harness connector from the high mounted stop ...