Nissan Sentra Service Manual: Main line between dlc and av circuit
Diagnosis procedure
1.Check harness continuity (open circuit)
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Disconnect the following harness connectors.
- ECM
- AV control unit
- Check the continuity between the data link connector and the av control unit harness connector.
- With navigation system and bose audio system
- With navigation system without BOSE audio system
Is the inspection result normal? YES (Present error)>>Check CAN system type decision again.
YES (Past error)>>Error was detected in the main line between the data link connector and the AV control unit .
NO >> Repair the main line between the data link connector and the AV control unit.
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Ecm branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ECM for damage, bend and ...
Other materials:
Moonroof (if so equipped)
Power moonroof
The moonroof will only operate when the ignition
switch is placed in the ON position. The power
moonroof is operational for a period of time, even
if the ignition switch is placed in the ACC or OFF
position. If the driver’s door or the front passenger’s
door is opened du ...
P0999 Shift solenoid F
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0999
SHIFT SOLENOID F
(Shift Solenoid F Control Circuit
High)
The TCM low brake solenoid valve current
monitor reading is 200 mA or ...
Precaution for work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
