Nissan Sentra Service Manual: Front wheel hub and knuckle
Inspection
COMPONENT PART
Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part if necessary.
- Move the wheel hub and bearing in the axial direction by hand. Make sure there is no looseness in the wheel hub and bearing.
Axial end play : Refer to FAX-49, "Wheel Bearing".
- Rotate the wheel hub and bearing and make sure there is no unusual noise or other irregular conditions. If there are any irregular conditions, replace wheel hub and bearing.
Front drive shaft
Inspection
Check the following items, and replace the part if necessary.
Check drive shaft mounting point and joint for looseness and other damage.
CAUTION:
Replace entire drive shaft assembly whe ...
Other materials:
Emission control information label
The emission control information label is attached
to the underside of the hood as shown.
Tire and loading information label
The cold tire pressure is shown on the Tire and
Loading Information label. The label is located as
shown.
Air conditioner specification label
The air condit ...
Front wiper drive assembly
Exploded view
Wiper blade (RH)
Wiper arm (RH)
Wiper drive assembly
Wiper arm (LH)
Wiper blade (LH)
Removal and installation
REMOVAL
Remove the cowl top. Refer to EXT-26, "Removal and Installation".
Disconnect the harness connector from the wiper drive assembly.
...
Towing a trailer
Do not tow a trailer with your vehicle.
Flat towing
Towing your vehicle with all four wheels on the
ground is sometimes called flat towing. This
method is sometimes used when towing a vehicle
behind a recreational vehicle, such as a motor
home.
CAUTION
Failure to follow these guidelines c ...
