Nissan Sentra Service Manual: Front fog lamp
Removal and Installation
FOG LAMP
Removal
- Position the fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector".
- Disconnect the harness connector from the front fog lamp.
- Remove the screws and the front fog lamp.
Installation
Installation is in the reverse order of removal.
NOTE:
After installing, perform fog lamp aiming adjustment. Refer to EXL-117, "Aiming Adjustment".
FRONT FOG LAMP BULB
Removal
WARNING:
Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time
because dust, moisture, smoke, etc.
may affect the performance of the lamp.
- Position the front fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector".
- Disconnect the harness connector from the front fog lamp bulb.
- Rotate the front fog lamp bulb socket counterclockwise and remove.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.
Revision:
Front combination lamp
Exploded view
Large cover (not serviceable)
Small cover (not serviceable)
Front combination lamp
Halogen lamp bulb (high beam)
Turn signal lamp bulb
Turn signal lamp bulb socket
...
Door mirror turn signal lamp
Removal and installation
The door mirror side turn signal lamp is integrated into the door mirror
assembly and is serviced as an assembly.
Refer to MIR-18, "Exploded View". ...
Other materials:
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the tire sidewall between tread shoulder and
maximum section width. For example:
Treadwear 200 ...
P0138 HO2S2
DTC Logic
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time between rich and
lean than the air fuel ratio (A/
F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold)
causes the longer switching
time.
MALFUNCTION A
To judge the malfunction ...
U1000 CAN Comm circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and excellent
error detection ability.
Many electronic control units are equipped into vehicles, and e ...
