Nissan Sentra Service Manual: Ecm branch line circuit

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can system (type 5) / Ecm branch line circuit

Diagnosis procedure

1.Check connector

Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

Disconnect the connector of ecm.
Check the resistance between the ecm harness connector terminals.

Is the measurement value within the specification?

Is the measurement value within the specification? Yes >> go to 3.

No >> repair the ecm branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the ecm. Refer to ec-164, "diagnosis procedure".

Is the inspection result normal? Yes (present error)>>replace the ecm. Refer to ec-485, "removal and installation".

Yes (past error)>>error was detected in the ecm branch line.

No >> repair the power supply and the ground circuit.

Main line between dlc and hvac circuit

Diagnosis procedure 1.Check harness continuity (open circuit) Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Disconnect the following harness connector ...

Abs branch line circuit

Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electri ...

Other materials:

Description
NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. Before performing trouble diagnoses, read the вЂњWork FlowвЂќ in each section. After repairs, re-check that the problem has been comp ...

Flywheel
Exploded View Flywheel Removal and Installation REMOVAL Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Refer to TM-28, "Exploded View". Remove flywheel. Secure flywheel (1) using Tool (A), and remove b ...

Unit disassembly and assembly
Front coil spring and strut Exploded View Piston rod lock nut Strut mount insulator Strut mount bearing Bound bumper Coil spring Lower rubber seat Strut Steering knuckle Front Disassembly and Assembly DISASSEMBLY CAUTION: Do not damage the piston rod when removing comp ...