Nissan Sentra Owners Manual: Driving on snow or ice

Nissan Sentra Owners Manual / Starting and driving / Cold weather driving / Driving on snow or ice

WARNING

Wet ice (32°F, 0°C and freezing rain), very cold snow or ice can be slick and very hard to drive on. The vehicle will have much less traction or “grip” under these conditions. Try to avoid driving on wet ice until the road is salted or sanded.
Whatever the condition, drive with caution.
Accelerate and slow down with care. If accelerating or downshifting too fast, the drive wheels will lose even more traction.
Allow more stopping distance under these conditions. Braking should be started sooner than on dry pavement.
Allow greater following distances on slippery roads.
Watch for slippery spots (glare ice).
These may appear on an otherwise clear road in shaded areas. If a patch of ice is seen ahead, brake before reaching it. Try not to brake while on the ice, and avoid any sudden steering maneuvers.
Do not use the cruise control (if so equipped) on slippery roads.
Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of the exhaust pipe and from around your vehicle.

Special winter equipment

It is recommended that the following items be carried in the vehicle during winter: A scraper and stiff-bristled brush to remove ice and snow from the windows and wiper blades. A sturdy, fl ...

Engine block heater (if so equipped)

Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20°F (-7°C) or lower. WARNING Do not u ...

Other materials:

Description
NOTE: This vehicle is diagnosed using the CONSULT-III plus. When CONSULT is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests. Instrument lower panel LH ...

Making a call
To make a call from a phone connected to the vehicle’s Bluetooth® Hands-Free Phone System: NOTE: Available commands different if system is in Manual Control mode. See “Manual Control” in this section for more information. Press the button. The system will prompt you for a command. ...

Troubleshooting guide
The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solution in turn, starting with number 1, until the problem is resolved. Symptom Solution ...