Nissan Sentra Owners Manual: Door locks/unlocks precaution

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / NISSAN Intelligent Key® (if so equipped) / Door locks/unlocks precaution

Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have difficulty recognizing that the Intelligent Key is outside the vehicle.
After locking with the door handle request switch, verify the doors are securely locked by testing them.
To prevent the Intelligent Key from being left inside the vehicle, make sure you carry the Intelligent Key with you and then lock the doors.
Do not pull the door handle before pushing the door handle request switch. The door will be unlocked but will not open. Release the door handle once and pull it again to open the door.

Operating range

The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1. When the Intelligent Key battery is discharged or str ...

NISSAN Intelligent Key® Operation

You can lock or unlock the doors without taking the Intelligent Key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors by pushing the doo ...

Other materials:

Changing engine coolant
A NISSAN dealer can change the engine coolant. The service procedure can be found in the NISSAN Service Manual. Improper servicing can result in reduced heater performance and engine overheating. WARNING To avoid the danger of being scalded, never change the coolant when the ...

C1120, C1122, C1124, C1126 ABS In valve system
DTC Logic Dtc detection logic DTC Display Item Malfunction detected condition Possible causes C1120 FR LH IN ABS SOL When a malfunction is detected in front LH ABS IN valve. Harness or connector ABS actuator and electric unit (control unit) ...

Ecm branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES > ...