Nissan Sentra Service Manual: Condenser
Removal and installation
Removal
- Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER : Removal and Installation".
- Disconnect the harness connectors (1), remove the condenser bolt (A) and the condenser (2).
: Front
Installation
Installation is in the reverse order of removal.
Filament
Inspection and Repair
Inspection
When measuring voltage, wrap tin foil around the top of the negative
probe. Then press the foil against the wire with your finger.
Attach probe circui ...
Horn
...
Other materials:
Dtc/circuit diagnosis
Malfunction area chart
Main line
Branch line
Short circuit
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors fo ...
Washer tank
Exploded view
Washer tank inlet
Washer tank
Washer level switch
Washer tank seal
Washer pump
Removal and installation
REMOVAL
Drain the washer fluid.
Remove the front under cover. Refer to ext-30, "front under cover :
removal and installation".
Remove the fe ...
Intermittent Incident
DESCRIPTION
Sometimes the symptom is not present when the vehicle is brought in for
service. If possible, re-create the
conditions present at the time of the incident. Doing so may help avoid a No
Trouble Found Diagnosis. The fol-
lowing section illustrates ways to simulate the conditions/env ...
