Nissan Sentra Owners Manual: Car phone or CB radio

Nissan Sentra Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Car phone or CB radio

When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts.

WARNING

A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation.

Some jurisdictions prohibit the use of cellular phones while driving.
If you must make a call while your vehicle is in motion, the hands free cellular phone operational mode is highly recommended. Exercise extreme caution at all times so full attention may be given to vehicle operation.
If you are unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle.

CAUTION

Keep the antenna as far away as possible from the electronic control modules.
Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harnesses. Do not route the antenna wire next to any harness.
Adjust the antenna standing-wave ratio as recommended by the manufacturer.
Connect the ground wire from the CB radio chassis to the body.
For details, consult a NISSAN dealer.

Application Download

Once connected, the NissanConnect™ App will search your phone to determine which compatible applications are currently installed. The user will then choose which apps they want to bring into the ...

Bluetooth® Hands-Free Phone System without Navigation System (Type A) (if so equipped)

WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be ...

Other materials:

Illumination control switch signal circuit
Diagnosis procedure Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check combination meter input signal Turn ignition switch on. Check voltage between the following terminals of the illumination control switch. Is the inspection result normal? ...

Dtc/circuit diagnosis
U1000 can comm circuit Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic Dtc detection logic Consult display Dtc detection condition Possible cause Can comm circuit [u1000] When ipdm e/r cannot communicate with can comm ...

Preparation
Special Service Tools NOTE: The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...