Nissan Sentra Owners Manual: Before starting the engine

Nissan Sentra Owners Manual / Starting and driving / Before starting the engine

Make sure the area around the vehicle is clear.
Check fluid levels such as engine oil, coolant, brake and clutch fluid(if so equipped), and windshield-washer fluid as frequently as possible, or at least whenever you refuel.
Check that all windows and lights are clean.
Visually inspect tires for their appearance and condition. Also check tires for proper inflation.
Lock all doors.
Position seat and adjust head restraints/headrests.
Adjust inside and outside mirrors.
Fasten seat belts and ask all passengers to do likewise.
Check the operation of warning lights when the ignition switch is placed in the ON position.
See “Warning/indicator lights and audible reminders” in the “Instruments and controls” section of this manual.

NISSAN vehicle immobilizer system

The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interferenc ...

Starting the engine

Apply the parking brake. CVT model: Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The shift lever cannot be moved out of P (Park) and into any of the other gea ...

Other materials:

Body side trim
Exploded View Rear body side welt Front body side welt Tether clip Front pillar finisher Metal clip Dash clip Dash side finisher Harness protector Front kicking plate inner Center pillar lower finisher Rear kicking plate inner Cap Center pillar upper finisher Rear p ...

Front fog lamp circuit
Description The ipdm e/r (intelligent power distribution module engine room) controls the front fog lamp relay based on inputs from the bcm over the can communication lines. When the front fog lamp relay is energized, power flows from the front fog lamp relay in the ipdm e/r to the front fog ...

P0441 EVAP Control system
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0441 is displayed with other DTC such as P2122, P2123, P2127, P2128 or P2138, first perform trouble diagnosis for other DTC. In this evaporative emission (EVAP) control system, purge flow occurs during non-closed throttle conditions. Purge volu ...