Nissan Sentra Owners Manual: Air cleaner

Nissan Sentra Owners Manual / Maintenance and do-it-yourself / Air cleaner

The air cleaner filter should not be cleaned and

The air cleaner filter should not be cleaned and reused. Replace it according to the maintenance log shown in the “NISSAN Service and Maintenance Guide.” To remove the air cleaner filter:

Unlatch the retaining clips A .
Pull up at points B and remove.
Pull up and remove air cleaner housing C .
Remove the air cleaner filter, Wipe the inside of the air cleaner filter housing and the cover with a damp cloth, then replace air cleaner filter.

NOTE:

After installing a new air cleaner, make sure the air cleaner cover is seated in the housing and latch the clips.

WARNING

Operating the engine with the air cleaner removed can cause you or others to be burned. The air cleaner not only cleans the air, it stops the flame if the engine backfires. If it isn’t there, and the engine backfires, you could be burned. Do not drive with the air cleaner removed, and be careful when working on the engine with the air cleaner removed.
Never pour fuel into the throttle body or attempt to start the engine with the air cleaner removed. Doing so could result in serious injury.

In-cabin microfilter

The in-cabin microfilter restricts the entry of airborne dust and pollen particles and reduces some objectionable outside odors. The filter is located behind the trim panel near the accelerator pedal. Refer to the “NISSAN Service and Maintenance Guide” for change intervals.

If replacement is required, see your NISSAN dealer.

Spark plugs

Replacing spark plugs WARNINGBe sure the engine and ignition switch are off and that the parking brake is engaged securely. CAUTION Be sure to use the correct socket to remove ...

Windshield wiper blades

...

Other materials:

Rear combination lamp
Exploded View Rear combination lamp Rear turn signal lamp bulb Rear turn signal lamp socket LED lamp harness connector Rear combination lamp harness connector Back-up lamp bulb socket Back-up lamp bulb Disassembly and Assembly DISASSEMBLY WARNING: Do not touch bulb whil ...

P0444, P0445 EVAP Canister purge volume control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0444 PURG VOLUME CONT/V (Evaporative emission system purge control valve circuit open) An excessively low voltage signal is sent to ...

P0182, P0183 FTT Sensor
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0182 FTT SEN/CIRCUIT (Fuel temperature sensor ″A″ circuit low) An excessively low voltage from the sensor is sent to ...