Nissan Sentra Service Manual: Front wiper auto stop signal circuit
Component function check
1. Check front wiper (auto stop) operation
Consult data monitor
- Select “WIP AUTO STOP” of IPDM E/R DATA MONITOR item.
- Operate the front wiper.
- With the front wiper operation, check the monitor status.
Is the inspection result normal? YES >> Auto stop signal circuit is normal.
NO >> Refer to WW-41, "Diagnosis Procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to ww-24, "wiring diagram - with intelligent key" or ww-29, "wiring diagram - without intelligent key".
1. Check ipdm e/r output voltage
- Turn the ignition switch off
- Disconnect front wiper motor.
- Turn the ignition switch on.
- Check voltage between front wiper motor connector e1 and ground.
Is the inspection result normal? Yes >> replace front wiper motor. Refer to ww-62, "removal and installation".
No >> go to 2.
2. Check front wiper motor (auto stop) circuit continuity
- Turn the ignition switch OFF
- Disconnect ipdm e/r connector.
- Check continuity between ipdm e/r harness connector e46 and front wiper motor harness connector e1.
- Check continuity between ipdm e/r harness connector e46 and ground.
Is the inspection result normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the harness or connectors.
Front wiper motor hi circuit
Component function check
1. Check front wiper hi operation
Ipdm e/r auto active test
Start ipdm e/r auto active test. Refer to ww-15, "diagnosis description"
(with intelligent key ...
Front wiper motor ground circuit
Diagnosis procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With
Intelligent Key" or WW-29,
"Wiring Diagram - Without Intelligent Key".
1.Check ...
Other materials:
P0720 Output speed sensor
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0720
OUTPUT SPEED SENSOR
(Output Speed Sensor Circuit)
The output speed sensor value is less than
150 rpm continuously for 5 seconds ...
Moonroof unit assembly
Inspection
WIND DEFLECTOR
Open glass lid fully
Visually check for proper installation, damaged/deteriorated components,
or foreign objects within mechanism.
Correct as required for smooth operation.
Check for grease at the wind deflector arm (1) and pivot areas. If
necessary, apply ...
Dtc/circuit diagnosis
Power supply and ground circuit
Audio unit
AUDIO UNIT : Diagnosis Procedure
Regarding wiring diagram information, refer to av-88, "wiring diagram".
1.Check fuse
Check that the following fuses are not blown.
Are the fuses blown?
Yes >> replace the blown fuse after repairing ...
